
This 140-pound stone was recovered in July 2000 from the bank of a creek that feeds the Paluxy River near Glen Rose, 53 miles south of Fort Worth, Texas. The impressions show the dinosaur passed along the track after the human, indicating man and dinosaur co-existed. The fossil may be viewed in Dr. Carl Baugh's Creation Evidence Museum. This giant footprint contemporary with dinosaurs was also found in Dinosaur Park at Glen Rose. Pictured with my foot, it exceeds 45 cm (18 inches) in length. The cross-sectional cuts determined by compression studies that it was a woman's footprint. Estimates indicate her stature approximately 305 cm (10 feet) and 454 kg (1,000 lbs). Several strata of human prints with dinosaur prints have been excavated in this park. According to Dr. Carl Baugh, the archeologist who coordinated the excavations, these strata were laid down during the first few days of Noah's flood when water levels were low enough to allow daily tidal changes to form layers of mud so fleeing creatures could seek higher ground— the upper strata showed no prints. Obviously the people who lived contemporary with dinosaurs were intelligent, and the footprints indicate that they were quite human, as the large toe on primates is located close to the heel to facilitate clinging to branches.

This dinosaur footprint in cretaceous limestone on the banks of the Paluxy River is approximately 30 cm (one foot) across, and located with similar tracks. Early excavations in this area revealed human footprints inside the dinosaur tracks leading to rumors that the human prints had claws–later excavations uncovered human footprints up to 64 cm long (25 inches) next to the dinosaur prints—this discounted the doubters. A human handprint was also found. This confirms that dinosaurs occupied the arbitrary and spurious "cretaceous" period of geological history. Human prints contemporary with dinosaurs contradict modern evolution theories because mankind was not to evolve for another 75 to 100 million years.

This interesting photograph is of a hammer found in similar strata. It's iron head and wooden handle are solidified in sandstone. Metallurgical studies show that it was constructed of a type of iron that could not have been made under present atmospheric conditions. It is believed that before the flood our atmosphere was compressed to approximately twice its current density, and no ultraviolet radiation.
In June 1934, the Hahn family discovered a rock, sitting loose on a ledge beside a waterfall outside of London, Texas. The site primarily consists of 75-100 million years old cretaceous rock. Noticing this weathered rock had wood protruding from it, they cracked it open, exposing the hammer head. To verify that the hammer was made of metal, they cut into one of the beveled sides with a file. The bright metal in the nick is still there, with no detectable corrosion. The unusual metallurgy is 96% iron, 2.6% chlorine and 0.74% sulfur (no carbon). Density tests indicate exceptional casting quality.
The density of the iron in a central, cross-sectional plane shows the interior metal to be very pure, with no bubbles.
Modern industry cannot consistently produce iron castings with this quality, as evidenced by test results that show bubbles and density variations that have caused pump and valve bodies to break. The handle eye is partially coalifed with quartz and calcite crystalline inclusions, oval shaped, and roughly 1" x 1/2".
What do you think?